Jakprints Buys Saber Cutter from Colter & Peterson Dealer
Optimization of Cutting Procedure a Huge Advantage for Ohio Printer
FOR IMMEDIATE RELEASE
April 15 , 2008
Contact:
Bruce Peterson, President and CEO
Colter & Peterson
Phone: (973) 684-0901
Fax: (973) 684-0260
cp@colterpeterson.com
|
Click Here for larger view
The Saber 116 paper cutter’s control system was developed by C&P Microsystems, LLC, a division of Colter and Peterson.
|
Paterson, NJ –Graphco, a full-line equipment dealer for Colter & Peterson, recently sold a Saber 116 paper
cutter to Jakprints, a commercial printer, and installed the machine at their facility in Cleveland, OH.
Jakprints’ purchasing decision came after researching competing machines and realizing the 45-inch Saber paper cutter was the solution that would work best for them right out of the box.
“The Saber was the only paper cutter that would perform flawlessly with the customer’s existing system,” says Chris Manley, President of Graphco in Solon, OH, which serves markets in Ohio, Pennsylvania, West Virginia, Kentucky, Michigan and Indiana.
A deciding factor for Jakprints was the Saber’s control system developed by C&P Microsystems, LLC, a division of Colter & Peterson, which provides the functionality that the customer needed and could not get from a competitor. The Microcip software allows the importation and conversion of standardized CIP3/4 files into cutting programs. Due to its automatic programming features and easy-to-use graphic interfaces, the software also eliminates errors and reduces set-up times.
“The electronic interface with the customer’s pre-press area is the best versus the Saber’s competitors,” says Manley. “The way that its software optimizes the cutting procedure, especially in gang runs or complicated press sheets, is a huge advantage for them. The two-arm pull of the knife and the clamp makes for a much more reliable cutting process.”
* * *
About C&P Microsystems, LLC: A division of Colter & Peterson, C&P Microsystems, LLC has been the industry leader in paper cutting operating systems for 28 years. The company has installed over 20,000 systems worldwide.
About Colter & Peterson: Colter & Peterson is the largest independent distributor of paper cutters and paper handling equipment in North America. Founded in 1932, C&P now employees over seventy-five people working out of four locations in New Jersey, Iowa, and California. C&P is the manufacturer of the Microcut line of retrofit back gauge controllers and the worldwide distributor of Prism, Saber and Maxima paper cutters. It is also the North American distributor for all Wohlenberg, Baumann and Schneider Engineering products as well as Horauf trimmers. C&P has purchased the Harris-Seybold and Dexter-Lawson line of paper cutters and provides service and support for those models of machines as well.
<< Back to News
